D-Link G530 - Page 80

75D-Link G530 User Manual
Section 3 - Conguration
If you click on
Edit or Add Rule, the following options will appear:
Name: Enter a name for the rule. Alternatively, select the protocol/
Application Name from the drop-down menu. Depending on
a requested service, the router redirects the external service
request to an appropriate internal host.
Local IP: Enter the IP address of the device on your local network that
you want to direct the incoming service to. Alternatively, select
the device from the drop-down menu.
Protocol: Select a trac protocol to allow or deny (TCP, UDP, Both, or
Other).
Protocol Number: If you select Other as the protocol, enter the protocol number.
Refer to https://www.iana.org/assignments/protocol-numbers/
protocol-numbers.xhtml for Assigned Internet Protocol
Numbers.
External Port: If you select TCP, UDP, or Both as the protocol, enter the public
port you want to forward.
Internal Port: If you select TCP, UDP, or Both as the protocol, enter the
private port you want to open.
Schedule: Use the drop-down menu to select a time schedule that
the rule will be enabled on. The schedule may be set to
Always Enable, or you can create your own schedules in the
Schedules section. Refer to Time & Schedule - Schedule on
page 82 for more information.