Print Server Administration User’s Guide
Installing and Starting the PS Admin Program
9
♦ If you are using a screen resolution larger than 640 x 480
(standard VGA), you should use a “Small Fonts” setting.
♦ You need to have the IPX network protocol and the Novell
NetWare client services enabled. PS Admin uses the IPX
protocol for communicating with the print server.
You only need to have one workstation that meets the above
requirements. It is not necessary to run the PS Admin program on
every workstation. Ordinary network stations will still be able to
print to your D-Link print server.
If you will only be using TCP/IP (UNIX) and/or AppleTalk
protocols, you can use the telnet interface instead of the
Windows-based PS Admin. For more information about using the
telnet interface, see the Appendix: Telnet Interface
Administration section on page 111.
Installing PS Admin
Follow the procedure outlined below to install PS Admin:
1.
Insert PS Admin installation disk 1 into your system’s 3.5”
floppy drive (A: or B:).
2.
If you are using Windows 3.1x or Windows NT 3.51, choose
Run… from the Program Manager’s File menu. Under
Windows 95/Windows NT 4.x or later Windows-based
operating systems, choose Run… from the Start menu on
the taskbar. When the dialog box appears, type the pathname
of the Setup program on the floppy drive (A:\SETUP or
B:\SETUP) and click OK.
To Next Page
Loading...
Need help?
General
