Print Server Administration User’s Guide
Getting Started Setting up Your Print Server
17
Changing Print Server Port Settings
Your D-Link network print server provides a number of parallel
and/or serial printer ports. For each port, you can determine:
♦ The name of the port
♦ A comment describing the port
♦ For parallel ports,
◊ Whether or not data can be sent to the port at high speed
◊ Whether or not the attached printer supports HP’s PJL
(Printer Job Language) protocol.
♦ For serial ports,
◊ The serial port speed (baud rate), in bits per second.
◊ How many data bits are sent per byte
◊ How many stop bits are sent with each byte
◊ Whether or not a parity bit is sent, and if so what kind
(even or odd parity)
◊ Whether or not software flow control is used
(XON/XOFF)
◊ Whether or not hardware flow control should be used, and
if so what kind (DTR, RTS, or DTR/RTS).
To set the parameters for a printer port,
1.
Select the print server in the PS Admin main window’s server
name display (or extended server display).
To Next Page
Loading...
Need help?
General
