xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
97
delete ipif
Used to delet
e an interface.
Purpose
delete ipif [System] [ipv6addre
ss <ipv6networkaddr>]
Syntax
This
command is used to delete an interface. The System interface
cannot be deleted. By using this command, an IPv6 address can be
deleted from the ipif.
Description
Parameters
<ipv6networkaddr> Specifies the IPv6 network address.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete an IPv6 address of the System interface:
DES-3200-28:4#delete ipif System ipv6address FE80::200:1FF:FE02:303/128
Command: delete ipif System ipv6address FE80::200:1FF:FE02:303/128
Success.
DES-3200-28:4#
enable ipif_ipv6_link_local_auto
Used to ena
ble the auto configuration of a link local address when
no IPv6 address is configured.
Purpose
enabl
e ipif_ipv6_link_local_auto [System]
Syntax
This
command is used to enable the auto configuration of a link
local address when there are no IPv6 addresses explicitly
configured. When an IPv6 address is explicitly configured, the link
local address will be automatically configured, and the IPv6
processing will start. When there is no IPv6 address explicitly
configured, by default, a link local address is not configured and the
IPv6 processing will be disabled. By enabling this automatic
configuration, the link local address will be automatically configured
and the IPv6 processing will start.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the automatic configuration of a link local address for an interface:
DES-3200-28:4#enable ipif_ipv6_link_local_auto System
Command: enable ipif_ipv6_link_local_auto System
Success.
DES-3200-28:4#
To Next Page
Loading...
Need help?
General
