D-Link xStack DES-3200 Series - Forwarding Database Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
11
5
12
FORWARDING DATABASE COMMANDS
The Layer 2 Forwarding Database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table:
Command Parameters
create fdb <vlan_name 32> <macaddr> port <port>
create multicast_fdb <vlan_name 32> <macaddr>
config multicast_fdb <vlan_name 32> <macaddr> [add | delete] <portlist>
config fdb aging_time <sec 10-1000000>
delete fdb <vlan_name 32> <macaddr>
clear fdb [vlan <vlan_name 32> | port <port> | all]
show multicast_fdb {vlan <vlan_name 32> | mac_address <macaddr>}
show fdb {port <port> | vlan <vlan_name 32> | vlanid <vidlist> | mac_address
<macaddr> | static | aging_time}
config multicast
port_filtering_mode
[<portlist> | all] [forward_unregistered_groups |
filter_unregistered_groups]
show multicast
port_filtering_mode
Each command is listed, in detail, in the following sections: