xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
52
2
APPENDIX B - PASSWORD RECOVERY PROCEDURE
This document describes the procedure for resetting passwords on D-Link Switches.
Authenticating any user who tries to access networks is necessary and important. The basic authentication method used to accept
qualified users is through a local login, utilizing a Username and Password. Sometimes, passwords get forgotten or destroyed, so
network administrators need to reset these passwords. This document will explain how the Password Recovery feature can help
network administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily recover passwords.
Complete these steps to reset the password:
For security reasons, the Password Recovery feature requires the user to physically access the device. Therefore this feature is
only applicable when there is a direct connection to the console port of the device. It is necessary for the user needs to attach a
terminal or PC with terminal emulation to the console port of the switch.
Power on the switch. After the runtime image is loaded to 100%, the Switch will allow 2 seconds for the user to press the hotkey
[^] ( Shift + 6 ) to enter the “Password Recovery Mode”. Once the Switch enters the “Password Recovery Mode”, all ports on the
Switch will be disabled.
Boot Procedure V1.00.B003
-----------------------------------------------------------------------------
Power On Self Test ........................................ 100%
MAC Address : 00-19-5B-EC-32-15
H/W Version : A1
Please wait, loading V1.00.B015 Runtime image.............. 100 %
The switch is now entering Password Recovery Mode.._
The switch is currently in Password Recovery Mode.
>
To Next Page
Loading...
Need help?
General
