D-Link xStack DES-3200 Series - Dhcp Relay Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
18
0
20
DHCP RELAY COMMANDS
The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>} (1)
config dhcp_relay add ipif [System] <ipaddr>
config dhcp_relay delete ipif [System] <ipaddr>
config dhcp_relay option_82 state [enable | disable]
config dhcp_relay option_82 check [enable | disable]
config dhcp_relay option_82 policy [replace | drop | keep]
config dhcp_relay option_82
remote_id
[default | user_define <string 32> ]
show dhcp_relay {ipif [System]}
enable dhcp_relay
disable dhcp_relay
Each command is listed in detail in the following sections:
config dhcp_relay
Used to co
nfigure the DHCP/BOOTP relay feature of the switch.
Purpose
config d
hcp_relay {hops <value 1-16> | time <sec 0-65535>} (1)
Syntax
This
command is used to configure the DHCP/BOOTP relay feature.
Description
Parameters
hops <value 1-16>  Specifies the maximum number of relay agent
hops that the DHCP packets can cross.
time <sec 0-65535>  If this time is exceeded; the Switch will not
relay the DHCP packet.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To config DHCP relay:
DES-3200-28:4#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DES-3200-28:4#