D-Link xStack DES-3200 Series - Page 184

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
17
9
Example usage:
To enable IGMP Access Control for all ports:
DES-3200-28:4# config igmp access_authentication ports all state enable
Command: config igmp access_authentication ports all state enable
Success.
DES-3200-28:4#
show igmp access_authentication ports
Used to displ
ay the current IGMP Access Control configuration.
Purpose
sho
w igmp access_authentication ports [all | <portlist>]
Syntax
This
command is used to display the current IGMP Access Control
configuration.
Description
Parameters
<portlist>  specifies a range of ports to be displayed.
Non
e.
Restrictions
Example usage:
To display IGMP Access Control status for ports 1 to 4:
DES-3200-28:4# show igmp access_authentication ports 1-4
Command: show igmp access_authentication ports 1-4
Port Authentication State
------ ---------------------
1 Enabled
2 Disabled
3 Disabled
4 Enabled
DES-3200-28:4#