D-Link xStack DES-3200 Series - Lldp Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
35
4
44
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table:
Command Parameters
enable lldp
disable lldp
config lldp
message_tx_interval
<sec 5 - 32768 >
config lldp
message_tx_hold_multiplier
< int 2 - 10 >
config lldp tx_delay < sec 1 - 8192 >
config lldp reinit_delay < sec 1 - 10 >
config lldp
notification_interval
<sec 5 - 3600 >
config lldp ports [<portlist>|all] notification [enable | disable]
config lldp ports [<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
config lldp ports [<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
config lldp ports [<portlist>|all] basic_tlvs [all | {port_description |
system_name | system_description | system_capabilities}]
[enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_pvid [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name
32> ] | vlanid <vlanid_list> ] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name
32> ] | vlanid <vlanid_list> ] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_ protocol_identity [all | { eapol | lacp
| gvrp | stp }] [enable | disable]
config lldp ports [<portlist>|all] dot3_tlvs [all |
{mac_phy_configuration_status | link aggregation |
power_via_mdi | maximum_frame_size}] [enable | disable]
config lldp
forward_message
[enable | disable]
show lldp
show lldp mgt_addr {ipv4 <ipaddr>}
show lldp ports {<portlist>}
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}