D-Link xStack DES-3200 Series - Mld Snooping Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
33
3
41
MLD SNOOPING COMMANDS
The MLD Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config mld_snooping [vlan <vlan_name 32> | vlanid <vidlist> | all] { state [enable
| disable] | fast_done [enable | disable] } (1)
config mld_snooping querier [vlan <vlan_name 32> | vlanid <vidlist> | all]
{ query_interval <sec 1-65535> | max_response_time
<sec 1-25> | robustness_variable <value 1-255> |
last_listener_query_interval <sec 1-25> | state [enable |
disable] | version <value 1-2>} (1)
config mld_snooping
mrouter_ports
<vlan_name 32> [add | delete] <portlist>
config mld_snooping
mrouter_ports_forbidden
<vlan_name 32> [add | delete] <portlist>
enable mld_snooping
disable mld_snooping
show mld_snooping {vlan <vlan_name 32> | vlanid <vidlist>}
show mld_snooping group {vlan <vlan_name 32> | vlanid <vidlist>}
show mld_snooping
mrouter_ports
{vlan <vlan_name 32> | vlanid <vidlist>} { [static | dynamic
| forbidden]}
Each command is listed, in detail, in the following sections.
config mld_snooping
Used to co
nfigure MLD snooping on the Switch.
Purpose
config mld
_snooping [vlan <vlan_name 32> | vlanid <vidlist> | all]
{ state [enable | disable] | fast_done [enable | disable] } (1)
Syntax
This
command is used to configure MLD snooping on the Switch.
Description
<vlan_
name 32> - The name of the VLAN for which MLD snooping is
to be configured.
Parameters
<vidlist> - The range of VIDs to be configured.
all – Select to configure all the VLANs on the Switch.
state - Allows you to enable or disable the MLD snooping function for
the chosen VLAN.
fast_done - Enable or disable the MLD snooping fast done function. If
enabled, the membership is immediately removed when the system
receives the MLD done message.
Only Administrator-level users
can issue this command.
Restrictions
Example usage: