D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
43
8
54
COMMAND HISTORY COMMANDS
The Command History commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
?
dir
config command_history <value 1-40>
show command_history
Each command is listed, in detail, in the following sections:
?
Used to displ
ay all commands in the Command Line Interface (CLI).
Purpose
? {<comm
and>}
Syntax
This
command is used to display all of the commands available through
the Command Line Interface (CLI).
Description
{<comm
and>} – Entering the question mark with an appropriate
command will list all the corresponding parameters for the specified
command, along with a brief description of the commands function and
similar commands having the same words in the command.
Parameters
Non
e.
Restrictions
Example usage
To display all of the commands in the CLI: