D-Link xStack DES-3200 Series - Vlan Trunking Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
31
9
38
VLAN TRUNKING COMMANDS
The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist>|all] state [enable|disable]
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Used to ena
ble the VLAN trunk function.
Purpose
enabl
e vlan_trunk
Syntax
Whe
n the VLAN trunk function is enabled, the VLAN trunk ports shall be
able to forward all tagged frames with any VID.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the VLAN Trunk:
DES-3200-28:4#enable vlan_trunk
Command: enable vlan_trunk
Success.
DES-3200-28:4#
disable vlan_trunk
Used to disab
le the VLAN trunk function.
Purpose
disa
ble vlan_trunk
Syntax
This
command is used to disable the VLAN trunk function.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable the VLAN Trunk: