D-Link xStack DES-3200 Series - Switch Utility Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
67
9
SWITCH UTILITY COMMANDS
The Switch Utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename
64> image_id <value 1-2> | cfg_fromTFTP [<ipaddr> |
<ipv6addr>] <path_filename 64> {increment}]
config firmware image_id <value 1-2> [delete | boot_up]
show firmware information
show config [current_config | config_in_nvram]
upload [cfg_toTFTP | log_toTFTP] [<ipaddr> | <ipv6addr>]
<path_filename 64>
enable autoconfig
disable autoconfig
show autoconfig
ping <ipaddr> {times <value 0-255>} {size <value 1-60000>}
{timeout <sec 1-99>}
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000>|
timeout <value 1-10>}
traceroute <ipaddr> {ttl <value 1-60>} {port <value 30000-64900>}
{timeout <sec 1-65535>} {probe <value 1-9>}
config terminal _line [default | <value 20-80>]
show terminal_line
Each command is listed, in detail, in the following sections: