xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
23
1
25
TRAFFIC SEGMENTATION COMMANDS
Traffic segmentation allows users to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied.
The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table
Command Parameters
config traffic_segmentation
<portlist>
forward_list [null | <portlist>] show traffic_segmentation
{<portlist>}
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Used to co
nfigure traffic segmentation on the Switch.
Purpose
config traffi
c_segmentation <portlist> forward_list [null | <portlist>]
Syntax
This
command is used to configure traffic segmentation on the
Switch.
Description
Parameters
<portlist> Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
null No ports are specified
<portlist> Specifies a range of ports for the forwarding list. This list
must be on the same Switch previously specified for traffic
segmentation (i.e. following the <portlist> specified above for config
traffic_segmentation).
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3200-28:4#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3200-28:4#
To Next Page
Loading...
Need help?
General
