D-Link xStack DES-3200 Series - Q-In-Q Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
32
3
39
Q-IN-Q COMMANDS
The Q-in-Q commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table:
Command Parameters
enable qinq
disable qinq
show qinq
show qinq ports {<portlist>}
config qinq ports [<portlist> | all] {role [uni | nni] | outer_tpid <hex 0x1–
0xffff> | trust_cvid [enable | disable] | vlan_translation
[enable | disable]} (1)
create vlan_translation [add cvid <vidlist> svid <vlanid 1-4094> | replace cvid
<vlanid 1-4094 svid <vlanid 1-4094>]
delete vlan_translation cvid [<vidlist> | all]
show vlan_translation cvid {<vidlist>}
config bpdu_tunnel ports [<portlist> | all] type [tunnel {stp | gvrp} | uplink | none]
show bpdu_tunnel
enable bpdu_tunnel
disable bpdu_tunnel
Each command is listed, in detail, in the following sections: