D-Link xStack DES-3200 Series - Mac-Based Access Control Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
41
4
51
MAC-BASED ACCESS CONTROL COMMANDS
The MAC-based Access Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table:
Command Parameters
enable mac_based_access_control
disable mac_based_access_control
config mac_based_access_control
password
<passwd 16>
config mac_based_access_control method [local | radius]
config mac_based_access_control
auth_failover
[enable | disable]
config mac_based_access_control
guest_vlan ports
<portlist>
config mac_based_access_control ports [<portlist> | all] {state [enable | disable] | mode [port_based |
host_based] | aging_time [infinite | <min 1-1440>] | hold_time [infinite |
<sec 1-300>] | max_users [no_limit | <value 1-128>]} (1)
create mac_based_access_control [guest_vlan <vlan_name 32>| guest_vlanid <vlanid 1-4094>]
delete mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid < vlanid 1-4094>]
clear mac_based_access_control
auth_mac
[ports [all | <portlist>] | mac_addr <macaddr>]
create mac_based_access_control_local
mac
<macaddr> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
config mac_based_access_control_local
mac
<macaddr> [vlan <vlan_name 32> | vlanid <vlanid 1-4094> |
clear_vlan ]
delete mac_based_access_control_local [mac <macaddr> | vlan <vlan_name 32> | vlanid <vlanid 1-4094>]
show mac_based_access_control { ports {<portlist> } }
show mac_based_access_control_local {[mac<macaddr> | vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
show mac_based_access_control
auth_state
{ports <portlist>}
config mac_based_access_control
max_users
[no_limit| <value 1-128>]
config mac_based_access_control
authorization attributes
{ radius [ enable | disable ] | local [ enable | disable ] } (1)
enable authorization attributes
disable authorization attributes
show authorization
config mac_based_access_control trap
state
[enable | disable]