D-Link xStack DES-3200 Series - Per-Queue Bandwidth Control Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
49
2
58
PER-QUEUE BANDWIDTH CONTROL COMMANDS
The Per-Queue Bandwidth Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table:
Command Parameters
config per_queue bandwidth_control { ports [ <portlist> | all ] } <cos_id_list> { max_rate [ no_limit | <value 64-
1024000 >] } (1)
show per_queue bandwidth_control {<portlist>}
Each command is listed, in detail, in the following sections: