D-Link xStack DES-3200 Series - Protocol Vlan Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
40
2
48
PROTOCOL VLAN COMMANDS
The Protocol VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
create
dot1v_protocol_group
group_id <int 1-16> {group_name <name 32>}
config
dot1v_protocol_group
[group_id <int 1-16> | group_name <name 32>][add protocol [ethernet_2 |
ieee802.3_snap] <hex> |delete protocol [ethernet_2 | ieee802.3_snap] <hex>]
delete
dot1v_protocol_group [ group_id <int 1-16> | group_name <name 32> | all ]
show
dot1v_protocol_group
{ [ group_id <int 1-16> | group_name <name 32> ] }
config port dot1v ports [ all ] [ add protocol_group [ group_id <int 1-16> | group_name <name 32>] [vlan
<vlan_name 32> | vlanid <int> ] { priority <value 0-7> } | delete protocol_group
[group_id <int 1-16> | all ] ]
show port dot1v {ports <portlist> }
Each command is listed, in detail, in the following sections: