D-Link xStack DES-3200 Series - Flow Meter Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
41
1
50
FLOW METER COMMANDS
The Flow Meter commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
config flow_meter
profile_id
<value 1-512> access_id < access_id >[[ rate <value 64-
1024000> burst_size <value 0-1016> rate_exceed
[drop_packet|remark_dscp <value 0-63>]] |delete]
show flow_meter {profile_id <value 1-512> {access_id <access_id>}}
Each command is listed, in detail, in the following sections.