D-Link xStack DES-3200 Series - Basic Switch Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
10
4
BASIC SWITCH COMMANDS
The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
enable password encryption
disable password encryption
create account [admin | user] <username 15>
config account <username> {encrypt [plain_text|sha_1] <password>}
show account
delete account <username>
show session
show switch
show serial_port
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]} (1)
enable clipaging
disable clipaging
enable telnet {<tcp_port_number 1-65535>}
disable telnet
telnet <ipaddr> {tcp_port <value 0-65535>}
enable web {<tcp_port_number 1-65535>}
disable web
save { [config | log | all]}
reboot {force_agree}
reset {[config | system ]} { force_agree}
login
logout
show config [current_config | config_in_nvram]
config terminal_line [default | <value 20-80>]
show terminal_line
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections: