D-Link xStack DES-3200 Series - Port Security Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
37
7
PORT SECURITY COMMANDS
The Port Security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
config port_security ports [<auth_portlist> | all] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-64> | lock_address_mode
[DeleteOnTimeout | DeleteOnReset | Permanent]} (1)
delete port_security_entry vlan_name <vlan_name 32> mac_address <macaddr> port
<auth_port>
clear port_security_entry port <auth_portlist>
show port_security {ports <auth_portlist>}
enable port_security trap_log
disable port_security trap_log
Each command is listed, in detail, in the following sections: