D-Link xStack DES-3200 Series - Mac Notification Commands

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
25
0
29
MAC NOTIFICATION COMMANDS
The MAC Notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command Parameters
enable mac_notification
disable mac_notification
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>} (1)
config mac_notification ports [<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports {<portlist>}
Each command is listed, in detail, in the following sections.
enable mac_notification
Used to ena
ble global MAC address table notification on the Switch.
Purpose
enabl
e mac_notification
Syntax
This
command is used to enable MAC address notification without
changing configuration.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable MAC notification without changing basic configuration:
DES-3200-28:4#enable mac_notification
Command: enable mac_notification
Success.
DES-3200-28:4#
disable mac_notification
Used to disab
le global MAC address table notification on the Switch.
Purpose
disa
ble mac_notification
Syntax
This
command is used to disable MAC address notification without
changing configuration.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable MAC notification without changing basic configuration: