xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
68
download
Used to do
wnload and install new firmware or a Switch
configuration file from a TFTP server.
Purpose
download [firmwa
re_fromTFTP [<ipaddr>| <ipv6addr>]
<path_filename 64> image_id <value 1-2> | cfg_fromTFTP
[<ipaddr>|<ipv6addr>] <path_filename 64> {increment}]
Syntax
This
command is used to download a new firmware or a Switch
configuration file from a TFTP server.
Description
Parameters
firmware_fromTFTP Download and install new firmware on the
Switch from a TFTP server.
cfg_fromTFTP Download a switch configuration file from a TFTP
server.
<ipaddr> The IP address of the TFTP server.
<ipv6addr> The IPv6 address of the TFTP server.
<path_filename> The DOS path and filename of the firmware or
switch configuration file on the TFTP server. For example,
C:\3200.had.
image_id <value 1-2> Specify the working section ID. The Switch
can hold two firmware versions for the user to select from, which
are specified by section ID.
increment Allows the download of a partial switch configuration
file. This allows a file to be downloaded that will change only the
switch parameters explicitly stated in the configuration file. All other
switch parameters will remain unchanged.
The TFTP se
rver must be on the same IP subnet as the Switch.
Only Administrator-level users can issue this command.
Restrictions
Example usage:
To download a configuration file:
To Next Page
Loading...
Need help?
General
