D-Link xStack DES-3200 Series - Page 11

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
6
DES-3200-28:4#show
Command: show
Next possible completions:
802.1p 802.1x access_profile account
acct_client address_binding arp_spoofing_prevention
auth_session_statistics auth_statistics authen
authen_enable authen_login authen_policy authorization
autoconfig bandwidth_control bpdu_tunnel command_history
config cos cpu_access_profile
dhcp_local_relay dhcp_relay dos_prevention
dot1v_protocol_group dscp_mapping error
fdb firmware flow_meter gratuitous_arp
greeting_message gvrp igmp igmp_snooping
ipif ipif_ipv6_link_local_auto iproute
ipv6 ipv6route jumbo_frame lacp_ports
limited_multicast_addr link_aggregation lldp
log log_save_timing loopdetect
mac_based_access_control mac_based_access_control_local
m
ac
_
based
_
vlan mac
_
notification max
_
mcast_group
mcast_filter_profile mirror mld_snooping
multicast multicast_fdb packet port
port_security ports pvid qinq
radius router_ports safeguard_engine scheduling
scheduling_mechanism serial_port session
sim smtp snmp sntp
ssh ssl stp switch
syslog tech_support terminal_line time
time_range traffic traffic_segmentation
trusted_host utilization vlan vlan_translation
vlan_trunk
DES-3200-28:4#
Figure 2 - 6. Next possible completions: Show Command
In the above example, all of the possible next parameters for the show command are displayed. At the next command prompt, the
up arrow was used to re-enter the show command, followed by the account parameter. The CLI then displays the user accounts
configured on the Switch.