D-Link xStack DES-3200 Series - Page 131

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
12
6
config traffic control_trap
Used to co
nfigure traffic control trap.
Purpose
config traffi
c control_trap [none | storm_occurred | storm_cleared |
both]
Syntax
This
command is used to configure whether storm control
notification will be generated or not when traffic storm events are
detected by the SW traffic storm control mechanism. Note: A traffic
control trap is active only when the control action is configured as
“shutdown”. If the control action is “drop,” there will no traps issued
when a storm event is detected.
Description
none –
No notification will be generated when a storm event is
detected or cleared.
Parameters
storm _occurred – A notification will be generated when a storm
event is detected.
storm_cleared  A notification will be generated when a storm event
is cleared.
both  A notification will be generated both when a storm event is
detected and cleared.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure traffic control for both:
DES-3200-28:4#config traffic control_trap both
Command: config traffic control_trap both
Success.
DES-3200-28:4#