D-Link xStack DES-3200 Series - Page 134

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
12
9
show bandwidth_control
Used to displ
ay the bandwidth control table.
Purpose
sho
w bandwidth_control {<portlist>}
Syntax
This
command is used to display the current bandwidth control
configuration on the Switch, on a port-by-port basis.
Description
Parameters
<portlist>  Specifies a port or range of ports to be viewed.
Non
e.
Restrictions
Example usage:
To display bandwidth control settings:
DES-3200-28:4#show bandwidth_control 1-5
Command: show bandwidth_control 1-5
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
---- ---------- ---------- ---------------- -------------
1 no_limit no_limit no_limit no_limit
2 no_limit no_limit no_limit no_limit
3 no_limit no_limit no_limit no_limit
4 no_limit no_limit no_limit no_limit
5 no_limit no_limit no_limit no_limit
DES-3200-28:4#