D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
16
4
Example usage:
To configure an interface’sIPv4 network address:
DES-3200-28F:4# config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DES-3200-28F:4#
To configure an interface’s DHCP option12 host name:
DES-3200-28F:4# config ipif System dhcp_option12 hostname switch1234
Command: config ipif System dhcp_option12 hostname switch1234
Success.
DES-3200-28F:4#
To configure an interface’s DHCP option12 state:
DES-3200-28F:4# config ipif System dhcp_option12 state enable
Command: config ipif System dhcp_option12 state enable
Success.
DES-3200-28F:4#
show ipif
Used to displ
ay the configuration of an IP interface on the Switch.
Purpose
show ipif
Syntax
This
command will display the configuration of an IP interface on
the Switch.
Description
Non
e.
Parameters
Non
e.
Restrictions

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)