D-Link xStack DES-3200 Series - Page 182

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
17
7
Example usage:
To configure IGMP snooping data driven learning’s maximum learned entry value:
DES-3200-28:4# config igmp
_
snooping data
_
driven
_
learning max
_
learned
_
entry
1
Command: config igmp_snooping data_driven_learning max_learned_entry 1
Success.
DES-3200-28:4#
clear igmp_snooping data_driven_group
Used to delet
e the IGMP snooping group learned by data driven.
Purpose
clea
r igmp_snooping data_driven_group [ [vlan_name <vlan_name
32> | vlanid <vlanid> ] [ all | <ipaddress>] | all ]
Syntax
This
command is used to delete the IGMP snooping group learned by
data driven.
Description
Note that this command is currently only for layer 2 switches.
Parameters
<vlan_name 32>  Specifies the VLAN name.
<vlanid>  Specifies the VLAN ID.
all  Delete all data-driven entries.
<ipaddr>  Specifies the IP Address.
all  Delete all IP addresses.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete all the groups learned by data-driven :
DES-3200-28:4# clear igmp_snooping data_driven_group all
Command: clear igmp_snooping data_driven_group all
Success.
DES-3200-28:4#
show igmp_snooping host
Used to displ
ay the IGMP host that has joined groups on specific
ports or specific VLANs.
Purpose
sho
w igmp_snooping host {[vlan_name <vlan_name 32> | vlanid
<vidlist> | ports <portlist> | group <ipaddr>] }
Syntax
This
command is used to display the IGMP host that has joined
groups on specific ports or specific VLANs.
Description
Parameters
<vlan_name 32>  Specifies the VLAN to display the host
information. If a VLAN or port is not specified, all joining hosts will be
displayed.
<vlanid> Specifies the VLAN ID.
<portlist> Specifies the list of ports to display the host information. If
a VLAN or port is not specified, all joining hosts will be displayed.