D-Link xStack DES-3200 Series - Page 191

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
18
6
Example usage:
To show the DHCP relay configuration:
DES-3200-28:4#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status : Disabled
DHCP/BOOTP Hops Count Limit : 4
DHCP/BOOTP Relay Time Threshold : 0
DHCP Relay Agent Information Option 82 State : Disabled
DHCP Relay Agent Information Option 82 Check : Disabled
DHCP Relay Agent Information Option 82 Policy : Replace
DHCP Relay Agent Information Option 82 Remote ID : 00-19-5B-EF-78-B5
Interface Server 1 Server 2 Server 3 Server 4
------------ --------------- --------------- --------------- --------------
DES-3200-28:4#
To show a single IP destination of the DHCP relay configuration:
DES-3200-28:4#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
Interface Server 1 Server 2 Server 3 Server 4
--------- ----------- ------------ ----------- --------------
System 10.58.44.6
DES-3200-28:4#
enable dhcp_relay
Used to ena
ble the DHCP/BOOTP relay function on the Switch.
Purpose
enabl
e dhcp_relay
Syntax
This
command is used to enable the DHCP/BOOTP relay function on
the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable DHCP relay:
DES-3200-28:4#enable dhcp_relay
Command: enable dhcp_relay
Success.
DES-3200-28:4#
disable dhcp_relay
Used to disab
le the DHCP/BOOTP relay function on the Switch.
Purpose