D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
18
9
Command Parameters
show acct_client
create 802.1x user <username 15>
delete 802.1x user <username 15>
show 802.1x user
Each command is listed, in detail, in the following sections:
enable 802.1x
Used to ena
ble the 802.1X server on the Switch.
Purpose
enabl
e 802.1x
Syntax
This
command is used to enable the 802.1X Network Access control
application on the Switch. To select between port-based or Host-based,
use the config 802.1x auth_mode command.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable 802.1X switch wide:
DES-3200-28:4#enable 802.1x
Command: enable 802.1x
Success.
DES-3200-28:4#
disable 802.1x
Used to disab
le the 802.1X server on the Switch.
Purpose
disa
ble 802.1x
Syntax
This
command is used to disable the 802.1X Network Access control
application on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable 802.1x on the Switch:
DES-3200-28:4#disable 802.1x
Command: disable 802.1x
Success.
DES-3200-28:4#