D-Link xStack DES-3200 Series - Page 201

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
19
6
Example usage:
To configure 802.1X authentication parameters for ports 1 to 20:
DES-3200-28:4#config 802.1x auth_parameter ports 1–20 direction both
Command: config 802.1x auth_parameter ports 1–20 direction both
Success.
DES-3200-28:4#
config 802.1x auth_protocol
Used to co
nfigure the 802.1X authentication protocol on the Switch.
Purpose
config 8
02.1x auth_protocol [local | radius_eap]
Syntax
This
command is used to configure the authentication protocol.
Description
local | radiu
s_eap – Specify the type of authentication protocol
desired.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DES-3200-28:4# config 802.1x auth_protocol radius_eap
Command: config 802.1x auth_protocol radius_eap
Success.
DES-3200-28:4#
config 802.1x init
Used to initial
ize the 802.1X function on a range of ports.
Purpose
config 8
02.1x init [port_based ports [<portlist> | all] | mac_based |
ports [<portlist> | all] {mac_address <macaddr>}]
Syntax
This
command is used to immediately initialize the 802.1X functions
on a specified range of ports or for specified MAC addresses
operating from a specified range of ports.
Description
port_b
ased – This instructs the Switch to initialize 802.1X functions
based only on the port number. Ports approved for initialization can
then be specified.
Parameters
mac_based  This instructs the Switch to initialize 802.1X functions
based only on the port number or the MAC address. MAC addresses
approved for initialization can then be specified.
ports <portlist>  Specifies a port or range of ports to be configured.
all  Specifies all of the ports on the Switch.
mac_address <macaddr>  Enter the MAC address to be initialized.
Only Administrator-level users
can issue this command.
Restrictions