D-Link xStack DES-3200 Series - Page 246

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
24
1
DES-3200-28:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DES-3200-28:4#
show arpentry
Used to displ
ay the ARP table.
Purpose
sho
w arpentry {ipif [System] | ipaddress <ipaddr> | static}
Syntax
This
command is used to display the current contents of the Switch’s ARP
table.
Description
Parameters
ipif [System]  The name of the IP interface, the end node or station for which
the ARP table entry was made, resides on.
ipaddress <ipaddr>  The network address corresponding to the IP interface
name above.
static – Displays the static entries to the ARP table.
Non
e.
Restrictions
Example Usage:
To display the ARP table: