D-Link xStack DES-3200 Series - Page 275

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
27
0
DES-3200-28:4#config authen server
_
host 10.1.1.121 protocol tacacs+ port
4321 timeout 12 retransmit 4
Command: config authen server
_
host 10.1.1.121 protocol tacacs+ port 4321
timeout 12 retransmit 4
Success.
DES-3200-28:4#
delete authen server_host
Used to delet
e a user-defined authentication server host.
Purpose
delete auth
en server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
Syntax
This
command is used to delete a user-defined authentication
server host previously created on the Switch.
Description
Parameters
server_host <ipaddr>  The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs  Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+  Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius  Enter this parameter if the server host utilizes the RADIUS
protocol.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To delete a user-defined TACACS+ authentication server host:
DES-3200-28:4#delete authen server_host 10.1.1.121 protocol tacacs+
Command: delete authen server_host 10.1.1.121 protocol tacacs+
Success.
DES-3200-28:4#
show authen server_host
Used to view
a user-defined authentication server host.
Purpose
s
how authen server_host
Syntax
This
command is used to view user-defined authentication server
hosts previously created on the Switch.
Description
The following parameters are displayed: