D-Link xStack DES-3200 Series - Page 30

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
25
To
restore all of the Switch’s parameters to their default values and have the Switch save and reboot:
DES-3200-28:4#reset system
Command: reset system
Are you sure you want to proceed with system reset, save and reboot?(y/n)
Load Factory Default Configuration... Done.
Saving all configurations to NV-RAM.. Done.
Please wait, the switch is rebooting...
login
Used to log in
a user to the Switch’s console.
Purpose
login
Syntax
This
command is used to initiate the login procedure. The user will be
prompted for a Username and Password.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To initiate the login procedure:
DES-3200-28:4#login
Command: login
UserName:
logout
Used to log o
ut a user from the Switch’s console.
Purpose
logout
Syntax
This
command terminates the current user’s session on the Switch’s
console.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To terminate the current user’s console session:
DES-3200-28:4#logout