D-Link xStack DES-3200 Series - Page 330

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
32
5
show qinq
Used to sh
ow global Q-in-Q
Purpose
s
how qinq
Syntax
This
command is used to show the global Q-in-Q status.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To show global Q-in-Q status:
DES-3200-28:4#show qinq
Command: show qinq
QinQ Status: Enabled
DES-3200-28:4#
show qinq ports
Used to sh
ow global Q-in-Q and port Q-in-Q mode status.
Purpose
sho
w qinq ports {<portlist>}
Syntax
This
command is used to show the global Q-in-Q status, including:
Description
port role in Q-in-Q mode and port outer TPID.
<po
rtlist> - Specifies a range of ports to be displayed.
Parameters
If no parameter is specified, the system will display all Q-in-Q port
information.
Non
e.
Restrictions
Example usage:
To show the Q-in-Q status for ports 1 to 4:
DES-3200-28:4#show qinq ports 1-4
Commands: show qinq ports 1-4
Port Role Outer TPID Trust_CVID VLAN Translation
----- ---- ---------- ---------- ----------------
1 NNI 0x88a8 Disabled Disabled
2 NNI 0x88a8 Disabled Disabled
3 NNI 0x88a8 Disabled Disabled
4 NNI 0x88a8 Disabled Disabled
Total Entries : 4
DES-3200-28:4#