D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
34
2
config igmp_snooping multicast_vlan
with the data traffic to be forwarded on the multicast VLAN. If none is
specified, the packet’s original priority will be used. The default
setting is none.
replace_priority - Specifies that packet’s priority will be changed by
the Switch based on the remap priority. This flag will only take effect
when remap priority is set.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure an IGMP snoop multicast VLAN:
DES-3200-28:4# config igmp
_
snooping multicast
_
vlan v1 add member
_
port 1,3
state enable
Command: config igmp
_
snooping multicast
_
vlan v1 add member
_
port 1,3 state
enable
Success.
DES-3200-28:4#
config igmp_snooping multicast_vlan multicast_group
Used to configure the m
ulticast group which will be learned with the
specific multicast VLAN.
Purpose
config igm
p_snooping multicast_vlan_group <vlan_name 32> [ add
<mcast_address_list> | delete [<mcast_address_list> | all]]
Syntax
This
command is used to configure the multicast group which will be
learned with the specific multicast VLAN. There are two cases need to be
considered. The join packet will be learned with the multicast VLAN that
contain the destination multicast group. If the destination multicast group of
the join packet can not be classified into any multicast VLAN that this port
belong, then the join packet will be learned with the natural VLAN of the
packet.
Description
No
ove
mu
te: The same multicast group can not be
rlapped in different multicast VLANs. Multiple
lticast groups can be added to a multicast VLAN.
Parameters
<vlan_name 32>  The name of the multicast VLAN to be configured, each
multicast VLAN is given a name that can be up to 32 characters.
<mcast_address_list> - Add or delete the list of multicast groups that will
be learned with the specified multicast VLAN.
all - All multicast groups will be deleted from the specified multicast VLAN.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To add a group to a multicast VLAN:

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)