D-Link xStack DES-3200 Series - Page 373

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
36
8
DES-3200-28:4# show lldp ports 1
Command: show lldp ports 1
Port ID : 1
---------------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disable
Advertised TLVs Option :
Port Description Disable
System Name Disable
System Description Disable
System Capabilities Disable
Enabled Management Address
(NONE.)
Port VLAN ID Disable
Enabled Port_and_protocol_VLAN_ID
(NONE)
Enabled VLAN Name
(NONE.)
Enabled protocol_identity
(NONE.)
MAC/PHY Configuration/Status Disable
Power Via MDI Disable
Link Aggregation Disable
Maximum Frame Size Disable
DES-3200-28:4#
show lldp local_ports
Used to displ
ay the per-port information currently available for populating
outbound LLDP advertisements.
Purpose
sho
w lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Syntax
This
command is used to display the per-port information currently
available for populating outbound LLDP advertisements.
Description
<po
rtlist> - Specify a range of ports to be configured.
Parameters
When a port list is not specified, information for all ports will be displayed.
brief - Display the information in brief mode.
normal - Display the information in normal mode. This is the default
display mode.
detailed - Display the information in detailed mode.
Non
e.
Restrictions
Example usage
To display outbound LLDP advertisements for individual ports in detail: