xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
38
1
To display DoS prevention information for Land Attack:
DES-3200-28:4# show dos_prevention land_attack
Command: show dos_prevention land_attack
DoS Type: Land Attack
State: Enabled
Action: Mirror
Port: 7
Priority: 5
Rx Rate(Kbit/sec): 1024
Frame Counts: 10000
DES-3200-28:4#
To display DoS prevention information for Blat Attack:
DES-3200-28:4# show dos_prevention blat_attack
Command: show dos_prevention blat_attack
DoS Type: Blat Attack
State: Enabled
Action: MirrorToPort
Port: 7
Priority: no_change
Rx Rate(Kbit/sec): no_limit
Frame Counts: 10500
DES-3200-28:4#
clear dos_prevention counters
Used to cle
ar the counters of the prevention of each DoS attack.
Purpose
clea
r dos_prevention counters { land_attack | blat_attack | smurf_attack |
tcp_null_scan | tcp_xmascan | tcp_synfin | tcp_syn_srcport_less_1024}
Syntax
This
command is used to clear the counters of the prevention of each
DoS attack.
Description
The type of DoS attack. Po
ssible values are as follows:
Parameters
land_attack
blat_attack
smurf_attack
tcp_null_scan
tcp_xmascan
tcp_synfin
tcp_syn_srcport_less_1024
Only Administrator-level users
can issue this command.
Restrictions