D-Link xStack DES-3200 Series - Page 389

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
38
4
create address_binding ip_mac ipaddress
Used to creat
e an IP-MAC-port binding entry.
Purpose
cre
ate address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all]}
Syntax
This
command is used to create an IP-MAC-port binding entry.
Description
<ipa
ddr> The IP address of the device where the IP-MAC-port binding
is made.
Parameters
<macaddr> The MAC address of the device where the IP-MAC-port
binding is made.
<portlist> - Specifies a port or range of ports to be configured for
address binding.
all – Specifies that all ports on the Switch will be configured for address
binding.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To create address binding on the Switch:
DES-3200-28:4#create address
_
binding ip
_
mac ipaddress 10.1.1.3 mac
_
address
00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3 mac_address 00-
00-00-00-00-04
Success.
DES-3200-28:4#
config address_binding ip_mac ipaddress
Used to co
nfigure an IP-MAC-port binding entry.
Purpose
config a
ddress_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all]}
Syntax
This
command is used to configure an IP-MAC-port binding entry.
Description
<ipa
ddr> - The IP address of the device where the IP-MAC-port binding is
made.
Parameters
<macaddr> - The MAC address of the device where the IP-MAC-port
binding is made.
<portlist> - Specifies a port or range of ports to be configured for address
binding.
all – Specifies that all ports on the Switch will be configured for address
binding.
Only Administrator-level users
can issue this command.
Restrictions