D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
40
7
show port dot1v
Used to displ
ay the VLAN to be associated with untagged packets
ingressed from a port based on the protocol group.
Purpose
sho
w port dot1v {ports <portlist> }
Syntax
This
command is used to display the VLAN to be associated with
untagged packets ingressed from a port based on the protocol group.
Description
portlist – Spe
cifies a range of ports to be displayed.
Parameters
If not specified, information for all ports will be displayed.
Non
e.
Restrictions
Example usage:
To display protocol VLAN information for ports 1 to 2:
DES-3200-28:4# show port dot1v ports 1-2
Command: show port dot1v ports 1-2
Port: 1
Protocol Group ID VLAN Name Protocol Priority
------------------- --------------------------------- -----------------
3 default -
4 VLAN300 -
5 marketing-1 -
Port: 2
Protocol Group ID VLAN Name Protocol Priority
------------------- --------------------------------- -----------------
3 default -
4 VLAN300 -
5 marketing-1 -
Total Entries: 6
DES-3200-28:4#