D-Link xStack DES-3200 Series - Page 463

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
45
8
show cfm fault
This
command is used to show the MEPs that have faults.
Purpose
sho
w cfm fault { md <string 22> { ma <string 22> } }
Syntax
This
command displays all the fault conditions detected by the MEPs contained in the specified MA
or MD.
Description
This display provides the overview of the fault status by MEPs.
ma <string 2
2> - The name of the maintenance association (MA) to view faults for MEPs.
Parameters
md <string 22> - The name of the maintenance domain (MD) to view faults for MEPs.
Non
e.
Restrictions
Example usage
To view all MEP faults:
DES-3200-28F:4# show cfm fault
Command: show cfm fault
MD Name MA Name MEPID Status
----------- ----------- ----- ---------------------------
op_domain op1 1 Cross-connect CCM Received
DES-3200-28F:4#
show cfm port
This
command is used to show MEPs and MIPs created on a port.
Purpose
sho
w cfm port <port> {level <int 0-7> | direction [ inward | outward ] | vlanid <vlanid 1-4094>}
Syntax
This
command is used to show the MEPs and MIPs created on a port.
Description
port <portli
st> - The port for which to display CFM configuration.
Parameters
level <int 0-7> - Setting level of the MD to be shown. If not specified, all levels are shown.
direction – The direction of the MEP to be displayed.
inward - Inward facing (up) MEP only are displayed.
outward - Outward facing (down) MEP only are displayed.
If not specified, both directions and the MIP are shown.
vlanid <vlanid 1-4094> - VLAN identifier for settings displayed. If not specified, all VLANs are
shown.
Non
e.
Restrictions