D-Link xStack DES-3200 Series - Page 466

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
46
1
show cfm linktrace
This
command is used to show the link trace responses.
Purpose
sho
w cfm linktrace [ mepname <string 32> | mepid <int 1-8191> md <string 22> ma <string 22>]
{ trans_id <uint>}
Syntax
This
command is used to display the link trace responses to a CFM link trace.
Description
The maximum link trace responses a device can hold is 128.
mepna
me <string 32> - The MEP name of the MEP where the trace is initiated.
Parameters
mepid <int 1-8191> - The MEP identifier of the MEP where the trace is initiated.
md <string 22> - The name of the maintenance domain (MD) where the trace is initiated.
ma <string 22> - The name of the maintenance association (MA) where the trace is initiated.
trans_id <uint> - Identifier of the transaction to show.
Non
e.
Restrictions
Example usage
To view link trace results for trace of MEP “mep1”:
DES-3200-28F:4# show cfm linktrace mep mep1
Command: show cfm linktrace mep mep1
Trans ID Source MEP Destination
-------- ---------------- ------------------
26 mep1 00-20-a2-00-00-01
DES-3200-28F:4#