D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
51
2
config pppoe circuit_id_insertion state
Used to enable or disable t
he PPPoE circuit identifier insertion.
Purpose
config p
ppoe circuit_id_insertion state [enable | disable]
Syntax
When PPPoE circuit identifier insertion is enabled, the system
will insert the circuit ID
tag to the received PPPoE discover and request packet if the tag is absent, and
remove the circuit ID tag from the received PPPoE offer and session confirmation
packet.
Description
The inserted circuit ID contains the following information:
Client MAC address
Device ID
Port number
By default, the Switch IP address is used as the device ID to encode the circuit ID
option.
enabl
e – Enables PPPoE circuit ID insertion globally.
Parameters
disable – Disables PPPoE circuit ID insertion.
The function is disabled by default.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To globally enable PPPoE circuit identifier insertion:
DES-3200-28F:4# config pppoe circuit_id_insertion state enable
Command: config pppoe circuit_id_insertion state enable
Success.
DES-3200-28F:4#

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)