Dahua L Series User Manual

357
Figure 5-34
Please refer to the following sheet for detailed information.
Parameter
Function
SSID
It is to set SSID name. You can use this name to search the
device.
Password
It is to set SSID password. You can use this password to
connect to the network.
Security
Select authentication from the dropdown list.
Start IP/End IP
Input start IP and end IP. The NVR can allocate the IP address
in the range you specified here.
WPS
Click WPS button to enable WPS function. After the network
camera enabled this function, it can automatically connect to the
network.
Remote device
In the list, you can view the network camera(s) that connected
to the NVR. It includes signal intensity, IP, MAC address, bit
rate, channel number, type, status and etc.
5.10.2.3.2 Advanced
Click Advanced button, the interface is shown as below. See Figure 5-35.

Dahua L Series Specifications

General

Brand	Dahua
Model	L Series
Category	Network Hardware
Language	English