Dahua XVR5116HS User Manual

425
Figure 4- 154
2. Set parameters.

Name: Input customized rule name.

Period: System can generate an alarm once the object in the zone is
missing for the specified period.
 Target filter: Click , you can set filter object size. Each rule can set
two sizes (min size/max size). Once the object is smaller than the min
size or larger than the max size, there is no alarm. Please make sure
the max size is larger than the min size.
3. Left click mouse to draw a zone, until you draw a rectangle, you can right
click mouse.
4. Click OK.
Complete drawing missing object detection rule.
Step 3 Click , it is to set parameters.
Please refer to chapter 4.9.3.3 motion detect to set other parameters.
Step 4 Check the Enable box to enable missing object detection function. Click Apply or
Save to complete setup.
Device begins missing object detection.
4.9.3.7 Face Detect (Optional)

Dahua XVR5116HS Specifications

General

USB Interface	2 USB 2.0 ports
Power Supply	DC 12V/2A
Video Output	1 HDMI, 1 VGA
Operating System	Embedded Linux
Video Compression	H.264+/H.264
Analog Camera Input	16 channel, BNC
IP Camera Input	Up to 16 channels
Audio In/Out	1/1, RCA
Display Resolution	1920 × 1080, 1280 × 1024, 1280 × 720
Network Interface	1 RJ-45 Port (10/100 Mbps)
HDD	1 SATA port, up to 6 TB
Dimensions	260 mm × 238 mm × 48 mm (W × D × H)
Smart Functions	SMD Plus
VGA Output	1920 × 1080, 1280 × 1024, 1280 × 720
Operating Temperature	-10°C to +55°C
Operating Humidity	10%–90% (RH), non-condensing