dallmeier DF4910HD-DN - Page 63

DF4910HD-DN | DDF4910HDV-DN-IM/-SM
www.dallmeier.com 63
 Select a zone (1 – 4) you would like to dene by using the appropriate radio button (op-
tion button).
 Click and hold the left mouse button and draw a rectangle (going from upper left to
lower right) over the relevant image area you would like to hide (mask) in the camera.
The selected image area is indicated in red.
If the selected image area does not meet your requirements, use the mouse and click
on an unmasked area.
The red masking is then removed and a new image area can be selected.
 If the selected image area meets your requirements, activate the dened zone by se-
lecting the appropriate checkbox.
 Click OK to apply the settings.
 If you want to dene another image area as a Privacy Zone, select the appropriate
radio button and proceed as described above.
However, if the combined area of all already activated zones amounts to more than
10% of the entire image, you cannot mask any more zones.
In that case, reduce the size of the already dened zones and save the settings again
by clicking OK. Then, dene the new zone.
 Finally, click OK in order to save all settings.
You should always activate and save each dened zone rst (“OK”) before dening an-
other zone.
In order to display masked image areas again, deactivate the appropriate checkbox and
click “OK”. The dened image area remains saved in the camera as long as you do not
click into an unmasked image area within the corresponding zone. Thus, you can always
activate or deactivate the masking for an already dened image area.