Dalsa Linea SWIR GigE Series - Page 103

Linea SWIR GigE Series Camera Technical Specifications
•
101
External Inputs: Using a Balanced Driver
• External Input maximum current is limited by camera circuits to a maximum of 10 mA.
• Warning: Only one External Signal can be used (input 1 or 2).
RS-422
Compatible
Transmitter
10
9
8
7
6
5
4
3
2
1
Camera IO
Interface
Only one Input can be used
in this configuration
.
!
External Signal
(
Common Ground )
(
Input
1 )
( Input 2 )
Figure 58: External Inputs with Balanced Driver Source
Output Signals Electrical Specifications
External Outputs Block Diagram
Protection
Current
Limiter
Protection
Current
Limiter
Output 2 (
pin 8)
Output
1 (pin
6)
Output Common Power
(pin 4)
Figure 59: External Outputs Block Diagram
External Output Details and DC Characteristics
• Programmable output strobe mode, event notification, etc (outputLineSource feature).
• Outputs are open on power-up with default factory settings.
• A software reset will not reset the outputs to open state if the outputs are closed.
• A user setup configured to load on boot will not reset the outputs to open state if the outputs
are closed.
• No output signal glitch on power-up or polarity reversal.
• Typical Operating Common Power Voltage Range: +3 V to 28 Vdc at 24 mA.
• Maximum Common Power Voltage Range: ±30 Vdc.
• Maximum Output Current: 36 mA