Dial back
This function is used during modem connection and when trans-
ferring logs to a service company. This is what happens:
- The service company calls the monitoring unit.
- The dial back function is enabled.
- The connection is broken.
- After a short while the monitoring unit itself rings the set desti-
nation. The destination can then retrieve logs and alarms.
The following settings are available:
Type the name.
Enter the password.
Type in the phone number.
If there are more Remote destinations (Destinations 2, 3 and 4), they
must be set up in the same way.
To Next Page
Loading...
Need help?
General
