0-11 Edit Set-up
Option: Function:
Select the set-up to be edited (i.e. programmed) during opera-
tion; either the active set-up or one of the inactive set-ups.
[0] Factory setup Cannot be edited but it is useful as a data source to return the
other set-ups to a known state.
[1]
*
Set-up 1
Set-up 1
[1] to
Set-up 4
[4] can be edited freely during opera-
tion, independently of the active set-up.
[2] Set-up 2
[3] Set-up 3
[4] Set-up 4
[9] Active Set-up Can also be edited during operation. Edit the chosen set-up from
a range of sources: LCP, FC RS485, FC USB or up to five fieldbus
sites.
0-12 This Set-up Linked to
Option: Function:
To enable conflict-free changes from one set-up to another dur-
ing operation, link set-ups containing parameters which are not
changeable during operation. The link will ensure synchronising
of the ‘not changeable during operation’ parameter values when
moving from one set-up to another during operation. ‘Not
changeable during operation’ parameters can be identified by
2. How to Programme FC 300 Programming Guide
30
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
2
To Next Page
Loading...
