Danfoss VLT 6000 HVAC Series User Manual

Mains supply 3 x 525-600 V
According to international requirements VLT type 6102 6122
Output current
I
VLT,N
[A] (525-550 V)
113 137
I
VLT, MAX
(60 s) [A] (525-550 V) 124 151
I
VLT,N
[A] (551-600 V)
108 131
I
VLT, MAX
(60 s) [A] (551-600 V) 119 144
Output
S
VLT,N
[kVA] (550 V) 108 131
S
VLT,N
[kVA] (575 V)
108 130
Typical shaft output [kW] (550 V) 75 90
[HP] (575 V) 100 125
Max. cable cross-section to motor
[mm
2
]
4,5
[AWG]
2,4,5
2 x 70
2 x 2/0
Max. cable cross-section to loadshar-
ing and brake
[mm
2
]
4,5
[AWG]
2,4,5
2 x 70
2 x 2/0
Rated input current
I
L,N
[A] (550 V) 110 130
I
L,N
[A] (575 V)
106 124
I
L,N
[A] (690 V) 109 128
Max. cable cross-section
power supply
[mm
2
]
4,5
[AWG]
2,4,5
2 x 70
2 x 2/0
Min. cable cross-section to motor and
power supply
[mm
2
]
4,5
[AWG]
2,4,5
35
2
Min. cable cross-section to brake and
loadsharing
[mm
2
]
4,5
[AWG]
2,4,5
10
8
Max. pre-fuses (mains) [-]/UL
[A]
1
200 250
Efficiency
3
0.98
Power loss [W] 2156 2532
Weight
IP 00 [kg]
82
Weight IP 21/Nema1 [kg] 96
Weight IP 54/Nema12 [kg] 96
Enclosure IP 00, IP 21/Nema 1 and IP 54/Nema12
1.
For type of fuse see section Fuses
2. American Wire Gauge.
3. Measured using 30 m screened motor cables at rated load and rated frequency.
4. Max. cable cross-section is the maximum possible cable cross-section allowed to be fitted on the terminals. Min. cable cross-section is the minimum
allowed cross-section. Always comply with national and local regulations on min. cable cross-section.
5. Connection bolt 1 x M10 / 2 x M10 (mains and motor), connection bolt 1 x M8 / 2 x M8 (DC-bus).
VLT
®
6000 HVAC Series
56 MG.61.B5.02 - VLT
®
is a registered Danfoss trademark

Danfoss VLT 6000 HVAC Series Specifications

General

Brand	Danfoss
Model	VLT 6000 HVAC Series
Category	DC Drives
Language	English